Open 24/7 · Greenville, TX

Faucet Repair in Greenville, TX

A dripping faucet wastes water all day and rarely fixes itself. For faucet repair in Greenville, TX, one call reaches a person at any hour, and the visit can cover every tap in the house.

Emergency? Call now, 24/7(903) 500-0026
Cutaway of a home showing the plumbing systemWater main and sewer main under the street, a water heater in the garage, a toilet, a kitchen sink, drain lines and the sewer line. Numbered hotspots link to services.Water mainSewer mainWater heater1Drains2Leaks and pipes3Sewer line4Toilets and fixtures5
  1. Describe the dripWhich faucet, where the water shows and how long it has run.
  2. The cause is foundThe plumber identifies the faucet type and the worn part inside.
  3. Part replaced, tap testedA new cartridge, seat or seal goes in and the tap is tested hot and cold.
Why call us

Why one number for a faucet that will not stop dripping

A minor leak is still a leak, and it deserves a quick fix.

  • Answered any timeA burst supply line at 10 p.m. reaches a person.
  • Same-day service is availableDescribe the drip and a visit can be set up the same day.
  • Every fixture in one visitKitchen, bathroom, laundry and outdoor taps can be fixed together.
  • No forms, no waiting for a replyOne call replaces an online request and a wait.
  • The cause explainedYou hear which part wore out and why.
We vs others

This number compared with the usual approach to a leaking faucet

Six differences, in the order that tends to matter.

UsBlackland PlumbingvsMany other plumbing companies
HoursOpen 24/7A running tap does not stop for the weekend.Weekday office hours
Reaching someoneA person answersExplain which tap is leaking and where.An online form
How soonSame-day service is availableThe drip does not run for another week.A visit days away
What jobs they handleFaucets, valves, disposals, drainsThe whole kitchen or bath in one visit.A single-fixture specialist
Local knowledgeGreenville and nearby townsDifferent suppliers mean different water, and the call starts there.Crews with no local feel
Price clarityThe page lists what moves the price. Ask about pricing when you call.The faucet model and its parts lead the list.A figure after the tap is already apart

Based on what is typical. Individual companies vary.

How it works

How faucet repair works, from the call to the last drip

Four steps. The first takes a minute.

  1. Turn off the water

    Close the valve under the sink or the main so the faucet can be opened.

  2. Call and describe

    Say which faucet, what it does and whether the handle is one or two.

  3. Open and inspect

    The faucet is taken apart and the worn part is identified.

  4. Replace and test

    A new part goes in. The faucet runs hot and cold, and the plumber checks for drips.

Pricing

What moves the price of faucet repair in Greenville, TX

A simple washer and a full cartridge swap are different jobs.

Faucet type

Compression, cartridge, ball and ceramic disc faucets use different parts and take different amounts of time to service.

Parts availability

Common faucets have cartridges on the shelf. Older or specialty models may require a part ordered in.

Condition of the valve and lines

If the shutoff valve under the sink is stuck or the supply line is worn, replacing them is part of the plan.

Repair or replace

When the body is corroded or the finish is failing, a new faucet may cost less than chasing parts.

Number of faucets

Several taps in one visit share the setup time.

Have this ready for the call

  • Which faucet is leaking
  • One handle or two
  • Brand or model if you can see it
  • Whether the shutoff valve under the sink turns

Ask about pricing when you call.

Call now, 24/7(903) 500-0026
What is inside

Four faucet designs and how faucet repair differs for each

Knowing the type tells you which part wore out and how easy the fix is.

The table shows the four common designs, how they leak and the usual repair. Any faucet can fail, but the pattern of failure differs by design.

TypeHow to spot itTypical failureUsual repair
CompressionTwo handles that you turn several times, often olderWorn washer or seat; drips from the spoutSimple parts
CartridgeA single handle or two, smooth actionWorn O-rings or a scaled cartridgeSwap the cartridge
BallA single handle on a round cap, common on kitchen faucetsWorn seals and springs; leaks at the baseRebuild kit
Ceramic discA single lever with a smooth, heavy feelCracked disc or worn sealsReplace the cylinder
The shape of the handle gives a clue to the design.

A drip from the spout wastes a surprising amount of water over a month, and it gets worse with time. If the drip is at a toilet or a tub, see toilet repair or shower repair.

Scale and flow

Mineral buildup and what it does to a tap

Hard water leaves deposits that choke aerators and wear cartridges faster.

Why flow drops

Minerals in the water collect on the faucet aerator, the small screen at the spout tip, and inside the cartridge. A faucet with weak flow or a spray that points sideways often needs nothing more than a soaked and scrubbed aerator. Vinegar loosens deposits well, but leave it on a finish like brass or a coated surface for only a few minutes.

How much scale you see depends on the water at your address. Greenville is served by the City and by nearby districts, and the water can differ between homes minutes apart, so check your bill or ask your water supplier about hardness. If scale is a recurring theme, a softener may help. See water softener installation and water filtration for the options.

Clean the aerator
  • Unscrew the aeratorTurn it counterclockwise by hand or with a cloth over pliers.
  • Soak the partsVinegar and a toothbrush clear most mineral crust.
  • Check the screenReplace it if it is torn or clogged beyond cleaning.
  • Flush the lineRun water with the aerator off to clear loose bits.
  • Reassemble and testHand tight is enough.
A five-minute fix that sometimes does the job.
Under the sink

The parts below the basin that mimic a faucet leak

Not every wet cabinet means a bad faucet. The cause is often one level down.

When you find water under the sink, dry everything and watch where the first drop forms. It tells you more than the puddle.

Where the drop formsLikely causeWhat helps
At the shutoff valve stemWorn packing nutGently tighten; replace the valve if it keeps seeping
At the supply line nutLoose connection or a worn washerSnug the nut a quarter turn; replace a bent or old line
On the faucet shank above the nutLoose mounting or a failed gasketTighten from below or replace the seal
At the drain trapLoose slip nut or a cracked washerHand-tighten and replace worn washers
Along the sprayer hoseCracked hose or loose fittingReplace the hose; check the weight on it
Dry first, then watch.

A cabinet with a musty smell may have a slow leak that has been going for a while. If the cabinet floor is soft, the leak may reach into the wall. See pipe repair in that case, or leak detection for a hidden source.

Outdoor spigots

Hose bibs in the Texas heat and the occasional freeze

Outdoor faucets go through more than indoor ones.

What outdoor taps endure

Hose bibs spend summers in the sun and a few nights each winter below freezing. A hose left attached traps water in the spigot and, when a hard freeze arrives, the pipe behind the handle can split. The damage often stays hidden until the thaw, when water sprays out behind the handle or into the wall. Some bibs are made to resist freezing, with the shutoff placed deeper inside the wall, but even those can fail if a hose stays connected.

Look for a drip from the spout when the tap is closed, water at the base where the spigot meets the wall, or a handle that spins without effect. Packing nuts leak when they wear. Vacuum breakers, the small cap on top, can leak or stick. See the guide on how to prevent frozen pipes for steps before a freeze, and pipe repair when the split is inside the wall.

Hose bib faults
ProblemCauseFix
Drip from spout, tap closedWorn washer or seatReplace the washer or the stem
Water behind the handleWorn packing or a loose nutTighten or replace the packing
Spray inside the wallSplit pipe after a freezeClose the inside shutoff and call
Leaks at the top capVacuum breaker failureReplace the breaker
Common hose bib faults
Match the symptom to the cause.
Kitchen faucets

Pull-down sprayers, side sprays and the faucets that work hardest

Kitchen taps move more water than any other, and they show it.

Where kitchen faucets wear

A pull-down faucet has a hose that runs under the sink to a weighted connector. If the sprayer will not return to its spot, the weight may have slipped or the hose twisted. A side spray leaks when its diverter, a small valve in the spout, wears out and sends water the wrong way. Cartridges here handle hot and cold, so they wear in months of daily use.

Because the kitchen sink often holds a disposal, a dishwasher line and the faucet’s supply lines in one cabinet, a repair often reveals another worn part. A plumber who opens the cabinet looks at them all. See garbage disposal repair for the other major kitchen sink fixture.

Kitchen faucet checks
  • Spray head cloggedSoak it and run a pin through the holes.
  • Hose weight slippedMove it back along the hose.
  • Diverter stuckClean or replace it.
  • Leak from the swivelReplace the O-rings at the spout base.
  • Handle tight or looseCheck the set screw and the cartridge nut.
Common kitchen faucet fixes.
Right now

What to do if a faucet will not shut off or leaks hard

Stop the water first, then call.

  1. Find the shutoff under the sink

    Turn the small oval handle clockwise.

  2. If it will not turn, close the main

    See the guide on the main water valve.

  3. Catch the drip

    Place a bowl or towel under the leak.

  4. Dry the cabinet

    Remove stored items and wipe the floor.

  5. Photograph the leak

    It helps the plumber see the pattern.

  6. Call

    Describe which faucet and what happens.

Hot water and sprayers

A hot water faucet that sprays can scald. Keep hands clear and shut the valve before reaching in. If water has reached an outlet, stay out of the wet area and switch off power only from a dry spot.

Questions

Questions about faucet repair in Greenville, TX

How much water does a dripping faucet waste?
A steady drip can waste many gallons a month. The amount rises as the worn part gets worse. Fixing it early stops the loss and spares the parts around it.
What does faucet repair in Greenville, TX involve?
The plumber closes the water, takes the faucet apart and finds the worn part. Common parts are the cartridge, washer, seat, O-ring or ceramic disc. After the new part goes in, the faucet is tested hot and cold and checked for drips.
Should I repair or replace my faucet?
If the body is sound and parts are available, repair is often enough. If the finish is peeling, the body is corroded or a part is no longer made, a new faucet is better. The plumber can tell you which.
What does faucet repair cost?
It depends on the faucet type, parts, access and whether the shutoff valves and supply lines need attention. Ask about pricing when you call and describe the faucet and what it does.
Why do two faucet repairs differ in price?
A washer swap on a compression faucet is quick. A rebuild of a single-lever kitchen faucet with a stuck cartridge and a corroded valve takes longer. The model and the condition of nearby parts make the difference.
Is same-day faucet repair available?
Same-day service is available, and calls are answered at any hour. If water will not stop, close the valve and call.
Can I fix a dripping faucet myself?
Many people can swap a washer or cartridge. The risks are a stuck handle, a damaged finish or a shutoff valve that breaks when turned. If the faucet is old or the valve will not hold, a plumber is the safer choice.
My faucet drips only when it is hot. Why?
The hot side of a faucet carries water at a higher temperature, which wears seals and washers faster. The hot cartridge or washer is the likely culprit. A plumber can replace that side.
Does hard water shorten faucet life?
Mineral buildup clogs aerators and wears cartridges faster. How hard your water is depends on your supplier and address. Check your bill or ask your supplier. See the water softener page if scale keeps coming back.
Why does my outdoor faucet leak behind the handle?
A worn packing nut or washer lets water creep up the stem. After a freeze, a split in the pipe inside the wall can also show up this way. If water enters the wall, close the shutoff inside the house and call.
Can low pressure be a faucet problem?
Yes, if only one faucet is weak. A clogged aerator, a scaled cartridge or a partly closed valve can all limit flow. If every tap is weak, the cause is elsewhere. See the low water pressure page.
Should I replace the shutoff valve at the same time?
If the valve is stiff, leaking or hard to turn, yes. A good valve makes every future repair easier. Mention it on the call and the plumber will check it when the cabinet is open.

Faucet repair in Greenville, TX, day or night

Call and a person answers. Say which tap is leaking and a visit can be set up the same day.

Call now, 24/7(903) 500-0026